Re: H-I-J '76 Nova re-fit.
 

Thank you.

Re: H-I-J '76 Nova re-fit.
 

Thank you Tim.

Re: H-I-J '76 Nova re-fit.
 

Door rubber, hatch rubber, carpet and brake pressure gauge showed up today.
https://i.imgur.com/jkF2Otw.jpg

Re: H-I-J '76 Nova re-fit.
 

Few things in gloss black powder today.
https://i.imgur.com/8jyapMV.jpg
https://i.imgur.com/qUju3yI.jpg

Re: H-I-J '76 Nova re-fit.
 

I have a bunch of stuff going on but I'll make it a point to get as much work done to the car as possible. I have to get some pieces together as I go, I'm a little disorganized right now, however I did get to start getting things checked over, laid out, and fitted today, like the dash pad.
https://i.imgur.com/hAeYcWc.jpg
https://i.imgur.com/CKdiRU9.jpg

Re: H-I-J '76 Nova re-fit.
 

Spent a few hours at the shop today gathering more parts and prepping for powdercoat. I'm getting tired of trying to clean these tiny parts so I figured I would try my vibratory polisher. I only had lizzard bedding for media as I use this for other stuff and that didn't work, after over an hour I didn't see much difference. I ran to Harbor Freight and bought some heavier media, I'll try it tomorrow.
https://i.imgur.com/T8WYHS3.jpg
https://i.imgur.com/SlxgDUK.jpg

Re: H-I-J '76 Nova re-fit.
 

Todd
Where i worked for 29 yrs. we made those fasteners.
TRW owned it for awhile than sold the company so they could invest
their money into Airbags at the time, (1992).....

Re: H-I-J '76 Nova re-fit.
 

No kidding. Airbags were probably a good bet.

Re: H-I-J '76 Nova re-fit.
 

Here is what I stuck in the little vibratory this morning, I'll leave it for a few hours and see what happens.
https://i.imgur.com/3gJAbvf.jpg
https://i.imgur.com/R2VAVJh.jpg

Re: H-I-J '76 Nova re-fit.
 

try NUT shells ---pecan/walnut something like that if you can find it---they are hard enough to clean the rust/crud off yet soft enough without damaging the metal--- plus they are cheap--- try a landscape place see if they have some