Pinion angle
What is the desired pinion angle, '91 Camaro Stocker, A.T.?
Thanks in advance for your replies. J.R. |
Re: Pinion angle
sorry ...was thinking 81 Camaro ..no comment..carry on
|
Re: Pinion angle
The desired pinion angle going down track should be as close to zero as possible at all angles for front and rear u-joints.
Put the front of the torque arm where it will be going down track and adjust to be as close as possible. The engine is offset to the right so be sure to look at those angles also. |
Re: Pinion angle
Thanks Frank. That info will be very helpful. J.R.
|
Re: Pinion angle
Frank
On a Mopar the engine is also offset to the right as is the pinion. Is the pinion in the Camaro offset also? How far off center is the engine/pinion? Just curious. |
Re: Pinion angle
Quote:
|
Re: Pinion angle
Pinion is offset 1'' in a factory 12 bolt. This is how you are able to use the same length axles both sides
|
All times are GMT -4. The time now is 09:36 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright © Class Racer.com. All Rights Reserved. Designated trademarks and brands are the property of their respective owners.