CLASS RACER FORUM - View Single Post

ss3011 · 01-19-2009, 11:16 PM

If you make the modification that Mark is suggesting, drill a hole through the dipstick tube just below the seal/o-ring that seals in the case. That will stop the straw effect, that could cause oil to spew out of the top of the dipstick tube. Also if you look at the early style, non locking dipstick, you will notice that the seal up by the handle has a notch in it. It also acts like a vent.

01-19-2009, 11:16 PM	#2
ss3011 Senior Member Join Date: Feb 2002 Location: Southeast Michigan Posts: 909 Likes: 70 Liked 239 Times in 114 Posts	Re: TH350 Blowing Fluid If you make the modification that Mark is suggesting, drill a hole through the dipstick tube just below the seal/o-ring that seals in the case. That will stop the straw effect, that could cause oil to spew out of the top of the dipstick tube. Also if you look at the early style, non locking dipstick, you will notice that the seal up by the handle has a notch in it. It also acts like a vent.