CLASS RACER FORUM - View Single Post

Ron Finney · 01-30-2011, 08:46 PM

Coan bushes their convertors so that you can use the turbo shaft without modifying the stator support on your existing pump. I'm sure you can have that done to yours. Then you can use the stronger turbo shaft. I had a TCI shaft twist too.....My coan PG shaft still looks good though. I have a good 8" convertor that is a PG spline so I still run the PG spline set up. I use the turbo spline when I switch to my 9" convertor or on my sons S/G S/ST car....It's kind of nice you just swap the shafts..... Someday though I will have all turbo setups. If you are going to invest any serious dollars....go the turbo route and be done.

Good Luck!

Ron
396V S/C

01-30-2011, 08:46 PM	#5
Ron Finney Member Join Date: Jul 2008 Location: Greenwood, IN Posts: 168 Likes: 0 Liked 0 Times in 0 Posts	Re: Best PG Input Shaft? Coan bushes their convertors so that you can use the turbo shaft without modifying the stator support on your existing pump. I'm sure you can have that done to yours. Then you can use the stronger turbo shaft. I had a TCI shaft twist too.....My coan PG shaft still looks good though. I have a good 8" convertor that is a PG spline so I still run the PG spline set up. I use the turbo spline when I switch to my 9" convertor or on my sons S/G S/ST car....It's kind of nice you just swap the shafts..... Someday though I will have all turbo setups. If you are going to invest any serious dollars....go the turbo route and be done. Good Luck! Ron 396V S/C __________________ Ron Finney 396V S/C