[Michael Beard]

Awesome, Ed, thanks! I just happened to have an unused toggle on my Painless panel that was already wired up for emergencies, just not connected to anything. Still had to tear the dash apart to figure out which wire and where it went since it's been years since we did it, but found it, and got everything set up properly and tested. Even flashed the ECU upgrade while I was at it.

Yep, already had a Dash #1 set up with just the necessary data points.

I'd made a bunch of changes to the fuel and spark maps this morning, and put it back in open loop. Starts better, sounds better at low rpms, and I leaned out the burnout areas of the map, which I'd had overly rich earlier. I'm very excited to have the internal data logger set up so that I don't have to get in trouble for being a dork and having the laptop bungied in the seat. ;-) Looking forward to doing some tuning. CalTracs are supposed to be here tomorrow, and should have them on the car for Richmond next week, then we can really get after it! :-)