CLASS RACER FORUM - View Single Post

Rick Bailey · 10-27-2011, 02:13 PM

Grant it, a pan/tray may be easier to work with, however I have a tuff time beliving that the tray can contain the fluids without being sucked out of the tray by wind drafts. In the case of a diaper, it's required that it made high enought to meet the block/head mating surfaces. And a tray I belive are only a few inches high........will they even reach the bottom of the pan. ?

Another note, several years ago, WJ was testing pan/trays. His position was " it dosen't work"

Look at the attached pic, and think about it !

Please Be Safe...........

Rick Bailey

(pic stolen from yb)

10-27-2011, 02:13 PM	#13
Rick Bailey Senior Member Join Date: Sep 2002 Posts: 502 Likes: 5 Liked 10 Times in 7 Posts	Re: engine diaper Grant it, a pan/tray may be easier to work with, however I have a tuff time beliving that the tray can contain the fluids without being sucked out of the tray by wind drafts. In the case of a diaper, it's required that it made high enought to meet the block/head mating surfaces. And a tray I belive are only a few inches high........will they even reach the bottom of the pan. ? Another note, several years ago, WJ was testing pan/trays. His position was " it dosen't work" Look at the attached pic, and think about it ! Please Be Safe........... Rick Bailey (pic stolen from yb) Attached Thumbnails __________________ Rick Bailey 3439 SC Last edited by Rick Bailey; 10-27-2011 at 02:30 PM.