[Andy Friar]

Originally Posted by Run to Rund

Most people remove old bushings with a blunt air chisel after putting rust penetrant on the areas where the bushings are pressed onto the arms. It is fairly common for the holes in the arms to be a little out of square, either factory, from use, or after removing the old bushings. You will find out when you try the solid steel bushings; bushings with soft inserts mask the issue. You may have to open up the holes in the arms a little, tack weld the outer bushing sleeves, and check for alignment with a 1/2" rod and the inner sleeves. Then you bend the ends of the arms until alignment is perfect. Upper arm bushings are often one piece and you just weld the bushings in as best you can, after opening up the holes in the arms enough to achieve perfect alignment. Press fit is OK if you end up with perfect alignment, and that may not happen. Use either high pressure chassis grease or moly cam lube on the friction surfaces.

I can do all these checks and will. Thanks for the tips.