CLASS RACER FORUM - View Single Post

Mike Jones · 03-28-2014, 05:44 PM

I broke the bell in my 12 second bracket car, 355/ TH-350 Camaro.
It had factory urethane mounts on the front crossmember and steel mounts bolted to the block, like they came in 1979
The driver side motor mount was slightly bent and the engine was
cocked up on the drivers side, just a bit. Could hardly tell, if you weren`t looking for it.
Found the bent mount when I pulled the motor.
Had rubber trans mount as well
Check the motor mounts are the same and not bent.
Just a thought...
Good luck.

03-28-2014, 05:44 PM	#8
Mike Jones VIP Member Join Date: Apr 2012 Location: Connecticut Posts: 1,125 Likes: 1,179 Liked 684 Times in 289 Posts	Re: Breaking bell housings I broke the bell in my 12 second bracket car, 355/ TH-350 Camaro. It had factory urethane mounts on the front crossmember and steel mounts bolted to the block, like they came in 1979 The driver side motor mount was slightly bent and the engine was cocked up on the drivers side, just a bit. Could hardly tell, if you weren`t looking for it. Found the bent mount when I pulled the motor. Had rubber trans mount as well Check the motor mounts are the same and not bent. Just a thought... Good luck.