CLASS RACER FORUM - View Single Post

rallye bob · 04-06-2014, 10:16 AM

I drilled a series of small (.250") holes around the original bell housing from the inside, as close to the pump as I could get. Then, on the outside of the bell, I drew a line, connecting the holes for a cutting guide. The instructions give you a measurement from the mounting surface of the bell to your cut. Your guide line (holes) should be close to that measurement... I finished off my cut edge with a hand held belt sander, and some 80 grit..
I just masked off any openings in the trans and did my complete install with the trans together..

04-06-2014, 10:16 AM	#5
rallye bob Member Join Date: Sep 2006 Location: Genoa, Illinois Posts: 489 Likes: 9 Liked 6 Times in 4 Posts	Re: J W Ultra bell installation I drilled a series of small (.250") holes around the original bell housing from the inside, as close to the pump as I could get. Then, on the outside of the bell, I drew a line, connecting the holes for a cutting guide. The instructions give you a measurement from the mounting surface of the bell to your cut. Your guide line (holes) should be close to that measurement... I finished off my cut edge with a hand held belt sander, and some 80 grit.. I just masked off any openings in the trans and did my complete install with the trans together.. Attached Thumbnails Last edited by rallye bob; 04-06-2014 at 10:18 AM.