Quote:
Originally Posted by Alan Nyhus
Rich, I would defintely get the driveshaft to a shop and have it checked for straightness & balance. It's hard to tell from the pics, but check the motor mounts and make sure there's not a mismatch of heights....there is a 'tall' and a 'short' motor mount. -Al
http://www.jegs.com/i/Energy+Suspens...1114G/10002/-1 |
I'll have to do some measuring today, but I think you are right about the difference in mount height just eyeballing it. I don't understand why someone would do that. I'll have to do some research for a local shop that can check out this drive shaft. Think those poly mounts would hold up?
After giving it some thought I believe I'm going to just go ahead and have a new drive shaft built and change over to 1350 yokes...no sense to keep pounding on this stock 45 year old shaft and 1310 u-joints. My only other decision then will be using poly or steel motor mounts.