Quote:
Originally Posted by Marvin Robinson
Won't resizing the rod end change the crush on the bearing?
|
Rods could be @ low side (small side) of spec,if they are new rods maybe under spec,new rods need to checked also,most are left under specs about .0005. just don't go over high side spec of rod housing bore
Try to polish that off crank won't be good,can't remove that much evenly by polishing
BTW if make journal .001-.0015 smaller clearance will open up around .003 or more,I think you meant you want to increase your clearance .001-.0015,but thought I would mention that just in case
Mike Taylor 3601