View Single Post
Old 05-29-2014, 01:18 AM   #238
HandOverFist
VIP Member
 
HandOverFist's Avatar
 
Join Date: Oct 2013
Location: Gulf Breeze, FL
Posts: 1,651
Likes: 8
Liked 33 Times in 16 Posts
Default Re: '67 Camaro E/SA redo

Quote:
Originally Posted by brent flynn View Post
Do you know for sure that its not dumping a little gas , from secondary rods into the rear flaps? I have a great source for parts... Cliff Ruggles, at Cliff's High Performance 740-397-2921 He sells the best parts, and know's how to make them run, as well.... He is in Mt Vernon , Ohio...Tell him Brent sent you...

He also sells adjustable choke pulloff's...they are the bomb... the only way to go...

What primary jets? Rear rods? My car has .065 primaries and .044 sec rods, with long tips( DA i believe) and it ran 10.81/122 on 462... and it ran
7.33 on a spinning 1st pass , at 88( out of the gas) in the 1/8 mile... with a 1.53(spinning 60ft)
This is the original carb that came with the car Brent. Has always run well until recently. A pro in Bowling Green KY has it and another carb atm...I'm sure he will find the problem. The original carb came with 68's in the primary (no rods and has never been touched). Secondary rods have seen AX down to the current DP without affecting 60' times. Ironically the car has gotten quicker even with the sorry launches...it must like those leaner rods with the current weather conditions because it runs like gangbusters on the big end.
__________________
Rich Taylor
I/SA - 321
HandOverFist is offline   Reply With Quote