CLASS RACER FORUM - View Single Post

impstocker · 07-20-2014, 10:22 PM

Hello, i have a question when you said the "pads were reversed" on the rear. I just did a 9 inch rear for a friends 64 Falcon. It was a junkyard rear that I started with without brakes. I believed I assembled the brakes right using a diagram, but one side the drum is tight. Seeing this is my first Ford experience i seem to run into these problems (on third set of front spindles-right now) Could my pads be "reversed" They seem to be the same side to side> I do.t want to hijack this thread, but i could use some help.
Will Lamprecht I/SA 65 Impala inprogress.

07-20-2014, 10:22 PM	#77
impstocker Member Join Date: Dec 2008 Location: Wingdale, NY Posts: 302 Likes: 27 Liked 53 Times in 16 Posts	Re: 1978 Mustang II Hello, i have a question when you said the "pads were reversed" on the rear. I just did a 9 inch rear for a friends 64 Falcon. It was a junkyard rear that I started with without brakes. I believed I assembled the brakes right using a diagram, but one side the drum is tight. Seeing this is my first Ford experience i seem to run into these problems (on third set of front spindles-right now) Could my pads be "reversed" They seem to be the same side to side> I do.t want to hijack this thread, but i could use some help. Will Lamprecht I/SA 65 Impala inprogress.