Quote:
Originally Posted by Tony Corley
Correct.
|
Thanks !
Next question--Subject: Rear End
The Stock section has only 2 paragraphs about the rear end.----Section 10A , page 6
REAR END
... Distance between backing plates may not
be changed. Any gear ratio that fits third-member case or housing permitted. Limited-slip or ratchet-type rear ends permitted. Reinforcement of spring perch permitted. Spools permitted only with aftermarket axles. Aftermarket axles not required for front-wheel-drive vehicles. Larger brakes may be used. Replacement rear end may be narrowed or widened to obtain original rear-end width. Bracing or beefing up the rear- end housing permitted...
It says that limited slip units may be used--axles and C-clip eliminators not mentioned with these.
Then it says spools are legal--only with aftermarket axles. Does not mention mini spools or C-clip elims.
Question: Is this covered in another section, like maybe general safety regulations or ? I'd heard that mini spools are not legal and all C-clip axles must use C-clip elims. So, what's the rule on this and where in the rule book is it found please ? Thanks !