Quote:
Originally Posted by Dragsinger
Check my idea about MSD and fuse panel mounting. [lean passenger seat forward for access] In addition, we installed a bar to mount the switch controller and dial-in controller
|
Larry, was just viewing your panel installation and you may want to revisit its installation since it may not be legal.
Although it requires the leaning of the passenger seat, it is still too close to the driver.
The following is an excerpt from the General Regulations, Section 20, Page 36, 3rd Paragraph:
"All removable or pin-type timing devices are prohibited. Two-steps
or other rev limiters that are adjustable by thumbwheel, replaceable
chips, and the like may not be within the driver’s reach and will
preferably be located outside the driver compartment."