[Andy Friar]

Relay and power distribution panel fab work. Bought a simple .750" dimple die from Summit. Any excuse to use it makes me happy.

Panel mock up. Trimming of lower profile required. Upper mounting point needed. More holes and dimples needed.

Panel completed, wired and labeled. Just missing the top mounting point bolt. I later thru in a 6 pt ARP SS I had.

Motor going in.

Nothing like getting those driver's side rear header bolts in place.

Wiring layout contemplation, fuel plumbing from trunk to engine bay completed.

Carb, water pump and alternator in place. Torque strap we made in place too. Dad messing with the distributor. Wiper motor block off plate made to mount coil.

Dad uttering NSFW words while trying to install the trans shield. Never did even come close to fitting. 'Universal' means universally never fits good, right?