Quote:
Originally Posted by Dave Muller
That last bit of work was done about ten days ago. But today was the first day I felt good enough to put in a reasonably full day in the garage. My son came over to give me a hand putting the front end sheet metal together.
It's amazing how much pushing, pulling, prying and even hammering it takes to get all these bolts to line up, but it finally came together. The alignment is still off, as I couldn't find the shims. I'll get some new ones and tighten everything up in a few days. On the other hand I was able to greatly improve the left door alignment, so I think that will work out okay.
Tomorrow I think I'll just do some more sanding and buffing on the paint. It still needs a lot of work. Then I'll get into the fuel lines and regulator next. Maybe mounting the seats will follow.
Hopefully I can figure out how the headlight buckets and grill attach. This car was a basket case, and I've never seen them together. But the exploded view in the body assembly book I have should help. |
I surprised to see harbor freight sells a container full of body shims. All different sizes.