[Bill Diehl]

Torque box reconstruction

The next series of photos will be of interest to some and not so much to others. This part of the project has been on the sidelines for awhile while I pondered the thought of eliminating the torque boxes alltogether, as bar 6A and 6B of the 25.5C floor would take its place and bars 2A would intersect the front factory frame rails.

But......since this is a "stock" eliminator project I came to the conclusion that

1) it would create to much controversy as not "stock" (even though I have approval in writing) and
2) I just was not satisfied with all the front end sheetmetal and the engine "hanging" from just the firewall becuase I have no motor plate or mid plate to work with