CLASS RACER FORUM - View Single Post - C4 Corvette build for Superstock I-J-K

Ernie Neal · 02-04-2017, 08:26 AM

fuel line bracket, it took me a minute to make this little bracket with 3 legs on an angle
1 photo when the car was going back to David Tincher's shop
2 photos of Door Slammer race, Tincher drove it
making the little lever that comes with cut-off usable for threaded rod style uni-ball connection. I filled with solder after drilling it with small holes. drilled and tapped 10-32, put a screw all the way through and used a flat washer and a jam nut. It worked as good as a billet one.

02-04-2017, 08:26 AM	#53
Ernie Neal Senior Member Join Date: Feb 2009 Location: Columbus, Indiana Posts: 529 Likes: 169 Liked 326 Times in 78 Posts	Re: C4 Corvette build for Superstock I-J-K fuel line bracket, it took me a minute to make this little bracket with 3 legs on an angle 1 photo when the car was going back to David Tincher's shop 2 photos of Door Slammer race, Tincher drove it making the little lever that comes with cut-off usable for threaded rod style uni-ball connection. I filled with solder after drilling it with small holes. drilled and tapped 10-32, put a screw all the way through and used a flat washer and a jam nut. It worked as good as a billet one. Attached Thumbnails