CLASS RACER FORUM - View Single Post

MIKE JONES 302 · 09-23-2018, 07:57 PM

Last week I decked the block. My goal was to use the factory steel shim head gasket, this didn't work out, the block measured 9.013 on one side and 9.027 on the other, bad factory machine work, so I went 9.00 and set it up for a Fel Pro head gasket .038. I will bore the block next.

09-23-2018, 07:57 PM	#39
MIKE JONES 302 Junior Member Join Date: Aug 2018 Location: Colorado Springs Colorado Posts: 28 Likes: 2 Liked 85 Times in 15 Posts	Re: 302 Chevrolet Engine Build Last week I decked the block. My goal was to use the factory steel shim head gasket, this didn't work out, the block measured 9.013 on one side and 9.027 on the other, bad factory machine work, so I went 9.00 and set it up for a Fel Pro head gasket .038. I will bore the block next. Attached Thumbnails