Quote:
Originally Posted by Dissident
Todd,
Did the clip break the end off of one end? What did the end of the pin look like? Such as did it ride on the cylinder wall a bit before it cocked in the piston and jerked in out of shape? 
An old guy's inquiring mind would like to know.  Thanks in advance.
Regards,
HB2 
Dissident |
Lock never broke, it was pushed out, pin was on the cyl wall and pulling on one side of the piston so it was jammed up in there. And yes, all of the locks were measured to make sure they had the correct groove size. before install.