CLASS RACER FORUM - View Single Post

Todd Geisler · 06-09-2022, 09:22 AM

Couple small projects Ive been working on while waiting for some wiring supplies to come in.

Been putting this off but finally got the quarter window boarders painted and installed.

Also got around to ordering the coil springs from Santhuff and got them slid in place.

Decided I wanted to mount the Rife sensor block on the underside of the top cowl section. Did not want to surface mount it so this offset bracket sets the sensor back just shy of being flush with the cowl/firewall surface.

And one of the last projects was designing and cutting out brackets to mount a 2" travel sensor to the shift linkage and tie into the Holley Dominator EFI.

Last little update is the engine is finally done and today is dyno day. Heading to the engine builders after lunch to try and learn a little EFI tuning.

06-09-2022, 09:22 AM	#175
Todd Geisler Member Join Date: Feb 2002 Posts: 328 Likes: 64 Liked 345 Times in 149 Posts	Re: 8.50 index build Couple small projects Ive been working on while waiting for some wiring supplies to come in. Been putting this off but finally got the quarter window boarders painted and installed. Also got around to ordering the coil springs from Santhuff and got them slid in place. Decided I wanted to mount the Rife sensor block on the underside of the top cowl section. Did not want to surface mount it so this offset bracket sets the sensor back just shy of being flush with the cowl/firewall surface. And one of the last projects was designing and cutting out brackets to mount a 2" travel sensor to the shift linkage and tie into the Holley Dominator EFI. Last little update is the engine is finally done and today is dyno day. Heading to the engine builders after lunch to try and learn a little EFI tuning.