[Larry Hill]

Talk about no knowing that you need a tool until you get the tool, a microscope is a good example. Modifying the oh so popular Gen 3 Hemi valve train to get it to “fit”. I wanted to observe all of the radii of the parts that needed some trimming. So I find the radius gage set from our crankshaft grinding days and find a few popular Chevy size missing. I must have left them close to the grinding wheel radius dresser when we sold the crank grinder. I figured out what we need to observe and unwrap new tool bits that supposedly have the correct radius, not. The radius was not full it had a point in the middle. It may have been ok to use but if there is very little parts support it’s not good enough.
As i think Dennis Miller would sign off with “ And so it goes”