CLASS RACER FORUM - View Single Post

Tim Lisson · 06-04-2014, 02:18 PM

Paul,

I'm sure there is smart engine builders out there that can make those gapless top rings work in a stocker set up, I tried and could not but I only do my own junk so take it for what its worth.... If it was me, I would pull the engine apart, scrub the cylinders with dawn dishsoap and brush them, remove the gapless top ring and throw them as far as you can, then find them and burry them so you don't try them again. Install some standard 5/64 rings and have fun.

They do seal awesome on compression, not sure what happens on the down stroke that makes them drink oil. I used two quarts in 10 dyno pulls and gave up. I heard of guys using a PCV set up to assist but with my tune port setup, it pulled oil out of the valve covers rapidly.

Good luck!

Tim

06-04-2014, 02:18 PM	#10
Tim Lisson Member Join Date: Aug 2003 Location: Solon Springs, WI Posts: 166 Likes: 0 Liked 0 Times in 0 Posts	Re: Fresh rebuild, oil everywhere Paul, I'm sure there is smart engine builders out there that can make those gapless top rings work in a stocker set up, I tried and could not but I only do my own junk so take it for what its worth.... If it was me, I would pull the engine apart, scrub the cylinders with dawn dishsoap and brush them, remove the gapless top ring and throw them as far as you can, then find them and burry them so you don't try them again. Install some standard 5/64 rings and have fun. They do seal awesome on compression, not sure what happens on the down stroke that makes them drink oil. I used two quarts in 10 dyno pulls and gave up. I heard of guys using a PCV set up to assist but with my tune port setup, it pulled oil out of the valve covers rapidly. Good luck! Tim