CLASS RACER FORUM - View Single Post

Dana Fitzpatrick · 02-21-2015, 08:41 PM

They are 4.56's. It's a Strange housing,could that make a difference?
Looking at an old Richmond gear instruction book I have, the pattern looks like one they show as having "low tooth contact,heavy in the root of the drive gear.Move the pinion out of the gear mesh,i.e. increase the pinion cone setting.Translation, please, Lol.
My present pattern doesn't look quite as low on the toe side as their drawing,though.

02-21-2015, 08:41 PM	#4
Dana Fitzpatrick Member Join Date: May 2009 Posts: 148 Likes: 4 Liked 10 Times in 6 Posts	Re: Ring and pinion set up question They are 4.56's. It's a Strange housing,could that make a difference? Looking at an old Richmond gear instruction book I have, the pattern looks like one they show as having "low tooth contact,heavy in the root of the drive gear.Move the pinion out of the gear mesh,i.e. increase the pinion cone setting.Translation, please, Lol. My present pattern doesn't look quite as low on the toe side as their drawing,though.