CLASS RACER FORUM - View Single Post

BillK · 10-19-2014, 08:52 PM

Keith,
Not sure where you are in Delaware, but once you get it off if you are close enough to Baltimore it might be worth running it to ATI and have the fit it for you. Have someone measure the crank snout with a good micrometer and take that micrometer with you to use as a reference. Any machine shop with a Sunnen rod hone should also be able to do it but a lot of guys don't have the proper mandrel for that small size. I bought both of them for Big Blocks and Small Blocks.

Hope this helps !

10-19-2014, 08:52 PM	#16
BillK Member Join Date: Nov 2005 Location: Waldorf Md Posts: 222 Likes: 10 Liked 26 Times in 15 Posts	Re: ATI Balencer removal Keith, Not sure where you are in Delaware, but once you get it off if you are close enough to Baltimore it might be worth running it to ATI and have the fit it for you. Have someone measure the crank snout with a good micrometer and take that micrometer with you to use as a reference. Any machine shop with a Sunnen rod hone should also be able to do it but a lot of guys don't have the proper mandrel for that small size. I bought both of them for Big Blocks and Small Blocks. Hope this helps ! __________________ Bill Koustenis