CLASS RACER FORUM - View Single Post

Jim Cimarolli · 10-23-2014, 01:23 AM

I had one like that. Put as much pressure on the puller as you think it will stand, then hit the jam bolt with a hammer right on the end and hit it hard. Keep tightening the puller and repeating the process. That is what I had to do to get one off that was not honed before it was installed. Good Luck.

10-23-2014, 01:23 AM	#17
Jim Cimarolli Senior Member Join Date: Mar 2002 Location: Sulphur Springs Texas Posts: 728 Likes: 112 Liked 135 Times in 40 Posts	Re: ATI Balencer removal I had one like that. Put as much pressure on the puller as you think it will stand, then hit the jam bolt with a hammer right on the end and hit it hard. Keep tightening the puller and repeating the process. That is what I had to do to get one off that was not honed before it was installed. Good Luck.