Quote:
Originally Posted by astikhossw
Where do you guys get the torque wrench that measure down to 5 inch pounds to set pinion pre load.I have been looking online and have not found one will go that low.
|
I will look and check for sure when I get back to the shop. But I think mine is a KD 2955. Its 1/4 inch drive. So I welded a old 1/4 socket to a socket I use when checking preload. That way I don't have to use several adapters to get there. I dont remember where I got mine as I have had it for 15-20 years but they are available online through many places.
Hope this helps
Rob