CLASS RACER FORUM - View Single Post

Buick6 · 01-05-2017, 09:12 PM

I'm rebuilding the front suspension on an 84' Regal for Stock Eliminator using Moog stock replacement rubber upper A arm bushings. There are "teeth" on both ends of the upper A arm bushings and on the inside of the cross shafts. What is the easiest way to remove the teeth? Small hand grinder? I am also going to hone the inside of the bushings to slide on the cross shafts easily. Anything else I should be doing? JR Weese

01-05-2017, 09:12 PM	#1
Buick6 Junior Member Join Date: Feb 2015 Location: Florence, SC Posts: 84 Likes: 16 Liked 15 Times in 6 Posts	Regal Upper A Arm Rebuild I'm rebuilding the front suspension on an 84' Regal for Stock Eliminator using Moog stock replacement rubber upper A arm bushings. There are "teeth" on both ends of the upper A arm bushings and on the inside of the cross shafts. What is the easiest way to remove the teeth? Small hand grinder? I am also going to hone the inside of the bushings to slide on the cross shafts easily. Anything else I should be doing? JR Weese