CLASS RACER FORUM - View Single Post - M-200 torque converter installation

R. Thorne · 06-18-2016, 10:17 AM

If you have access to a mike (or dial caliper) measure the torque converter snout o.d. of both converters. Just .001" bigger could be holding up the converter from seating fully. Sometimes just putting in new front pump bushing can do the same thing. Also, check for a burr on the end of the torque converter snout. Ron.

06-18-2016, 10:17 AM	#4
R. Thorne Member Join Date: May 2009 Posts: 171 Likes: 35 Liked 47 Times in 25 Posts	Re: M-200 torque converter installation If you have access to a mike (or dial caliper) measure the torque converter snout o.d. of both converters. Just .001" bigger could be holding up the converter from seating fully. Sometimes just putting in new front pump bushing can do the same thing. Also, check for a burr on the end of the torque converter snout. Ron.