|
|
![]() |
#1 |
Member
Join Date: Dec 2001
Location: Ontario Canada
Posts: 363
Likes: 113
Liked 7 Times in 5 Posts
|
![]()
putting together a second gen Camaro and when the motor is in , its higher in the rear, I'm sure the back should be lower but how many degrees ?
|
![]() |
![]() |
![]() |
#2 |
VIP Member
Join Date: Feb 2014
Location: Lakewood Washington
Posts: 1,407
Likes: 29
Liked 237 Times in 127 Posts
|
![]()
I've heard that the carb base should be level. Most manifolds are cut to slope down (I think 4 degrees).
Here's an interesting article from On All Cylinders regarding Jerry Bickel. It's not a Stocker, though. https://www.onallcylinders.com/2016/...s-drag-racing/
__________________
Dale Shearon 68 Mustang 6394 |
![]() |
![]() |
![]() |
#3 |
Member
Join Date: Nov 2014
Posts: 317
Likes: 621
Liked 174 Times in 87 Posts
|
![]()
There's two things to consider, one is the driveline angle and the other is that the engine is at least one degree up from level in the front so you don't get air trapped in the engine when filling with coolant.
https://www.iedls.com/uploads/files/...in%20Setup.pdf |
![]() |
![]() |
Liked |
![]() |
#4 | |
VIP Member
Join Date: Feb 2014
Location: Lakewood Washington
Posts: 1,407
Likes: 29
Liked 237 Times in 127 Posts
|
![]() Quote:
__________________
Dale Shearon 68 Mustang 6394 |
|
![]() |
![]() |
![]() |
#5 |
Senior Member
Join Date: Nov 2005
Location: Verrry South Jersey
Posts: 533
Likes: 127
Liked 230 Times in 122 Posts
|
![]() |
![]() |
![]() |
![]() |
#6 |
Senior Member
Join Date: Sep 2006
Location: Fulton County, PA
Posts: 540
Likes: 9
Liked 766 Times in 211 Posts
|
![]()
If this is a typical big tire backhalf car with the rear u-joint CL higher in the car than the front joint CL, having the engine nose down will help achieve desired operating angles on the joints while keeping the pinion angle negative or nose down - which is desired in a drag car.
Otherwise, using the OE engine 3 degree down in the rear mounting, you get into the "broken back" arraignment. Plus, the oil pan, headers, steering, etc all have to fit each other. It takes some planing and time mocking things up. |
![]() |
![]() |
![]() |
|
|