Wet plugs on one side.... - Page 2

Alex Denysenko · 03-30-2014, 04:34 PM

I'd replace the ignition box and coil. especially if it is a MDS 6 anything.

03-30-2014, 05:58 PM

does it have a crank scraper? What side of the engine is it again?

Bob Shaw · 03-30-2014, 06:55 PM

Todd is thinking what I am thinking. If the rings are not controlling the oil it will foul one side more than the other.

Adger Smith · 03-31-2014, 01:16 AM

Bob, I was thinking similar about oil except in the intake fit. Angle wrong and the bottom open to the valley or the end pads holding it up when tightened down or some brute tightened all of one side before he did the other.

Jody Lang · 04-01-2014, 01:12 PM

Thanks guys!

He still hasn't found the problem yet.

He's trying a new intake gasket next.

This motor has ran before. He took intake off to do a cam swap. Had a vacuum leak at intake so replaced that. Now it idles but has the current problem.

Ignition is a 6 not sure which one.

Car was started and ran intially without the MSD ground hooked up. Hooked it back up and no difference.

Maybe with ground not hooked up it did something to the box?

Also this is the 1st time he's used this brand of intake gaskets.

FireSale · 04-01-2014, 02:56 PM

A good ground is often overlooked and will mess up anything electronic, but I can't see it affecting only one side of the engine.

Dale

03-30-2014, 04:34 PM	#11
Alex Denysenko Senior Member Join Date: Jan 2002 Location: Michigan City IN Posts: 633 Likes: 0 Liked 4 Times in 3 Posts	Re: Wet plugs on one side.... I'd replace the ignition box and coil. especially if it is a MDS 6 anything. __________________ Alex Denysenko NHRA 3038 SS, 3305 STK - IHRA 6 SS, 330A STK Moneymaker Racing LaPorte Indiana 219-861-1214 www.moneymakerracing.net

03-30-2014, 05:58 PM	#12
Todd Hoven Guest Posts: n/a	Re: Wet plugs on one side.... does it have a crank scraper? What side of the engine is it again?

03-30-2014, 06:55 PM	#13
Bob Shaw Member Join Date: Jan 2002 Location: Sedalia, Mo Posts: 436 Likes: 321 Liked 316 Times in 61 Posts	Re: Wet plugs on one side.... Todd is thinking what I am thinking. If the rings are not controlling the oil it will foul one side more than the other. __________________ Bob Shaw V/SA 515

03-31-2014, 01:16 AM	#14
Adger Smith VIP Member Join Date: Dec 2001 Location: Texarkana Ark/TX Posts: 2,446 Likes: 575 Liked 880 Times in 311 Posts	Re: Wet plugs on one side.... Bob, I was thinking similar about oil except in the intake fit. Angle wrong and the bottom open to the valley or the end pads holding it up when tightened down or some brute tightened all of one side before he did the other. __________________ Adger Smith (Former SS) Last edited by Adger Smith; 03-31-2014 at 01:16 AM. Reason: sp

04-01-2014, 01:12 PM	#15
Jody Lang Member Join Date: Mar 2002 Posts: 306 Likes: 28 Liked 89 Times in 28 Posts	Re: Wet plugs on one side.... Thanks guys! He still hasn't found the problem yet. He's trying a new intake gasket next. This motor has ran before. He took intake off to do a cam swap. Had a vacuum leak at intake so replaced that. Now it idles but has the current problem. Ignition is a 6 not sure which one. Car was started and ran intially without the MSD ground hooked up. Hooked it back up and no difference. Maybe with ground not hooked up it did something to the box? Also this is the 1st time he's used this brand of intake gaskets.

04-01-2014, 02:56 PM	#16
FireSale VIP Member Join Date: Feb 2014 Location: Lakewood Washington Posts: 1,407 Likes: 29 Liked 237 Times in 126 Posts	Re: Wet plugs on one side.... A good ground is often overlooked and will mess up anything electronic, but I can't see it affecting only one side of the engine. Dale __________________ Dale Shearon 68 Mustang 6394