Woodfin's SS GT/TB construction series

Dragsinger · 10-13-2014, 05:44 PM

Columbus Day brought good progress.

The wheels are hanging on the axle tubes, no axles, housing tubes are still oversize length. When finished there will be about 1" between side wall and frame.

This week Monte [Mr Sheet Metal] of Team Woodfin will help me lay out the preliminary cuts for rear tubs. Then the bed can go on for a full cut and tub design.

One hurdle ahead, how to modify the bed floor for rearward roll bar struts. Monte will have a plan soon.

Also note triangulated bars frame to four link brackets

10-13-2014, 05:44 PM	#34
Dragsinger VIP Member Join Date: Jul 2008 Location: Liberty City [East Texas] Posts: 1,760 Likes: 5 Liked 99 Times in 60 Posts	Re: Woodfin's SS GT/TB construction series Columbus Day brought good progress. The wheels are hanging on the axle tubes, no axles, housing tubes are still oversize length. When finished there will be about 1" between side wall and frame. This week Monte [Mr Sheet Metal] of Team Woodfin will help me lay out the preliminary cuts for rear tubs. Then the bed can go on for a full cut and tub design. One hurdle ahead, how to modify the bed floor for rearward roll bar struts. Monte will have a plan soon. Also note triangulated bars frame to four link brackets Attached Thumbnails __________________ Larry Woodfin 471W

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode