|
![]() |
#23 |
VIP Member
Join Date: Oct 2013
Location: Gulf Breeze, FL
Posts: 1,651
Likes: 8
Liked 33 Times in 16 Posts
|
![]()
Brian -
The only vacuum line I have hooked up on the car is the one you recommended to the fuel pressure regulator. This sensor I replaced yesterday is the Map, correct? ![]() The Baro is one I have not seen. Where in the engine bay/harness would it be located if in fact it is still present? Edit : Ok, seems the sensor pictured above is actually a "BAP" sensor. I asked for a Map sensor at the parts store...any difference? At any rate this is the only sensor that resembles this in the engine compartment. Found this link for sensor locations... http://www.cjponyparts.com/tech-fox-body-engine/a/170/ Found this link also... http://sbftech.com/index.php?topic=19336.0 Fuel line fittings just arrived and I'm off to re-plumb the system as recommended. I also have a one wire alternator in hand so I can finally stop worrying with the thought of low voltage being a player in all of this.
__________________
Rich Taylor I/SA - 321 Last edited by HandOverFist; 05-02-2015 at 12:40 PM. |
![]() |
![]() |
|
|