Resurrecting the Rambler

[Pinballer]

(catching up into mid December)

After more engine bay clean-up and some more removal of unnecessary items in there, I washed it all off with prep-sol, touched up some areas that were crying for paint, and got things ready for the re-install of the mule motor. New motor and trans mounts went on, and the cherry picker came out. This is a real shoe-horn process with the trans attached, but if you go slow and keep re-adjusting the angles, it just does slide in.
You'll notice in the pictures that I tried to fabricate a more AMX-ish looking grille, it was a mesh type from the factory, but mine just isn't doing much for me. Nothing like having an original, so I'll keep looking.
After the drivetrain was installed, it kind of perks you up some to keep going harder. However, with the prime season for the pinball business I do, Christmas season, I'll be torn away from this project some for a while playing Santa and delivering some customer machines. When that calms down some it'll be back to build time. Need to get the dashboard all put back together next, and then finish up the front suspension rebuild on the left side.