C4 Corvette build for Superstock I-J-K

Ernie Neal · 01-29-2017, 10:23 AM

some more photos of the Mark Williams brakes I used on my lowered spindle position. The kit is for an 82-92 Camaro, less mounting brackets. AJE had these spindle stubs in stock. And the plates are now available at Cole Technologies, ask for David. The finished product has a backer plate of 3/16" on the through bolts.

couple of pics of the heater box cover

I drew the holes for the plug wires to go through the motorplate with enough resistance pushing them to retain them in place. The waterjet cutting was done by my good friend David Tincher. I did 7 designs on this, but we decided to go with this one.

Brake line tubing to the passenger side protected from the damper, plus some of the other little jump tubes.

01-29-2017, 10:23 AM	#26
Ernie Neal Senior Member Join Date: Feb 2009 Location: Columbus, Indiana Posts: 531 Likes: 169 Liked 328 Times in 80 Posts	Re: C4 Corvette build for Superstock I-J-K some more photos of the Mark Williams brakes I used on my lowered spindle position. The kit is for an 82-92 Camaro, less mounting brackets. AJE had these spindle stubs in stock. And the plates are now available at Cole Technologies, ask for David. The finished product has a backer plate of 3/16" on the through bolts. couple of pics of the heater box cover I drew the holes for the plug wires to go through the motorplate with enough resistance pushing them to retain them in place. The waterjet cutting was done by my good friend David Tincher. I did 7 designs on this, but we decided to go with this one. Brake line tubing to the passenger side protected from the damper, plus some of the other little jump tubes. Attached Thumbnails