Positive Rake Angle/Ride Height on Small Tire Ladder bar

CraigG · 09-21-2023, 01:26 PM

Hey Everybody,

I have a 4 degree positive rake angle on the ride height and wanted opinions .

Thanks, Craig

Still launching at 4,500 - 2-step with 5,000 still to grab.
Turbo 400 4.11 Pro gears with MT 10.5w x 28 slicks

Front suspension:
Comp Engineering single adjustable
Adjusted to 90/10 settings
5 x 18 #180 springs
Low friction control arm bushings and ball joints
Front end limiters set to no limiting
Total Race Weight 3440
Front weight 1860
Rear weight 1580
Percentage Basis Front to rear 55% to 45%

Rear suspension:
Full length Competition engineering adjustable ladder bars
Bottom hole lowest front heim end setting
Right bar - slight preload
“5 #150 lbs - springs with spring jacks
Comp Engineering Double Adjustables
Pinion angle 2 degrees negative
MT 10.5w x 28 slicks with tubes at 14 pds cold - best runs

Thanks Guys, Craig

09-21-2023, 01:26 PM	#1
CraigG Junior Member Join Date: May 2007 Location: Iowa Posts: 37 Likes: 0 Liked 8 Times in 7 Posts	Positive Rake Angle/Ride Height on Small Tire Ladder bar Hey Everybody, I have a 4 degree positive rake angle on the ride height and wanted opinions . Thanks, Craig Still launching at 4,500 - 2-step with 5,000 still to grab. Turbo 400 4.11 Pro gears with MT 10.5w x 28 slicks Front suspension: Comp Engineering single adjustable Adjusted to 90/10 settings 5 x 18 #180 springs Low friction control arm bushings and ball joints Front end limiters set to no limiting Total Race Weight 3440 Front weight 1860 Rear weight 1580 Percentage Basis Front to rear 55% to 45% Rear suspension: Full length Competition engineering adjustable ladder bars Bottom hole lowest front heim end setting Right bar - slight preload “5 #150 lbs - springs with spring jacks Comp Engineering Double Adjustables Pinion angle 2 degrees negative MT 10.5w x 28 slicks with tubes at 14 pds cold - best runs Thanks Guys, Craig Last edited by CraigG; 09-21-2023 at 01:28 PM. Reason: needed