Rod Ends..Do and Dont's?

DonMiller · 08-02-2009, 08:45 AM

I need to buy a set for a 4-link I am setting up. This is my first time(ladder bar before) and need 3/4-16 w/.750 bore....What do I look for and what do I avoid like the plague? Chromoly is a given and a high stensile strength is a must, but what else? One piece, 2 , 3? Teflon, Kevlar? I see ads for some over $100 each and some for $15....all rated about the same give or take 500 pounds...

What do you say?

08-02-2009, 08:45 AM	#1
DonMiller Junior Member Join Date: Oct 2008 Location: Clovis, CA Posts: 13 Likes: 0 Liked 0 Times in 0 Posts	Rod Ends..Do and Dont's? I need to buy a set for a 4-link I am setting up. This is my first time(ladder bar before) and need 3/4-16 w/.750 bore....What do I look for and what do I avoid like the plague? Chromoly is a given and a high stensile strength is a must, but what else? One piece, 2 , 3? Teflon, Kevlar? I see ads for some over $100 each and some for $15....all rated about the same give or take 500 pounds... What do you say? Last edited by DonMiller; 08-05-2009 at 05:09 PM.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode