cc3 box shifting on time?

dbochan · 07-28-2010, 06:27 PM

Yes, you would wire the shifter solenoid to stop B but make sure you use a relay in between the box and the shifter solenoid. The 1st timer is set for the "on " time to make the shift. The second timer is set to hold the shifter solenoid on for a set time to make sure the shifter has shifted into 2nd gear (1-2 seconds more than timer 1 is good). The 3rd and 4th timers are set to the same time which needs to be greater than the 2nd timer and cancel each other out. These timers work the same as for the inline T-stop on timer A. Are you going to be at Lebanon Valley this weekend?

07-28-2010, 06:27 PM	#4
dbochan Junior Member Join Date: Dec 2008 Location: East Hampton, CT Posts: 15 Likes: 0 Liked 0 Times in 0 Posts	Re: cc3 box shifting on time? Yes, you would wire the shifter solenoid to stop B but make sure you use a relay in between the box and the shifter solenoid. The 1st timer is set for the "on " time to make the shift. The second timer is set to hold the shifter solenoid on for a set time to make sure the shifter has shifted into 2nd gear (1-2 seconds more than timer 1 is good). The 3rd and 4th timers are set to the same time which needs to be greater than the 2nd timer and cancel each other out. These timers work the same as for the inline T-stop on timer A. Are you going to be at Lebanon Valley this weekend? Last edited by dbochan; 07-28-2010 at 06:29 PM.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode