Drive Shaft Tunnel Construction

mginnett · 01-21-2011, 09:49 PM

Thank you very much for the commentary, most appreciated. I think I may end up with a .120 steel tunnel, with 2 each 1" x .065 x 180 degree loops over the outsides well as the passage through the main rollcage hoop.
With the 360 degree setups I have seen, how much of a pain in the arse is it to pull the drive shaft / change the transmission?
This is a 66 Nova super gas style car, eventually will end up running mid to low eights.

01-21-2011, 09:49 PM	#6
mginnett Junior Member Join Date: Nov 2007 Posts: 8 Likes: 0 Liked 0 Times in 0 Posts	Re: Drive Shaft Tunnel Construction Thank you very much for the commentary, most appreciated. I think I may end up with a .120 steel tunnel, with 2 each 1" x .065 x 180 degree loops over the outsides well as the passage through the main rollcage hoop. With the 360 degree setups I have seen, how much of a pain in the arse is it to pull the drive shaft / change the transmission? This is a 66 Nova super gas style car, eventually will end up running mid to low eights.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode