'70 AMX C/S or D/S

tj310 · 11-01-2013, 04:25 PM

Good show Jeff ! HP on Tues

---Trevor

Jeff Lee · 11-01-2013, 07:08 PM

Still pulls to the right on launch. MPH seems a little slow. And left slick still rubs the body.
After the last run I came back & added some fuel pressure, a few flats preload right side bar and took some tin snips, hammer and what all to the body. Not pretty! Then somebody said Cal Method has an electric body grinder which he kindly loaned me. That's the most aggressive disk I've ever used; I think it would cut the car in half in 15 minutes!
When I got done, i got the clearance Needed and it doesn't even look bad with more radius. Some black duct tape and wolla! It's good now.
That was one awesome / fun wheelie and it went forward then started climbing to a pretty steep angle.

11-01-2013, 04:25 PM	#1
tj310 Member Join Date: Sep 2009 Location: Dresden On. Canada Posts: 460 Likes: 0 Liked 0 Times in 0 Posts	Re: '70 AMX C/S or D/S Good show Jeff ! HP on Tues ---Trevor

11-01-2013, 07:08 PM	#2
Jeff Lee VIP Member Join Date: Jul 2007 Location: Anthem, Arizona Posts: 2,766 Likes: 0 Liked 3 Times in 3 Posts	Re: '70 AMX C/S or D/S Still pulls to the right on launch. MPH seems a little slow. And left slick still rubs the body. After the last run I came back & added some fuel pressure, a few flats preload right side bar and took some tin snips, hammer and what all to the body. Not pretty! Then somebody said Cal Method has an electric body grinder which he kindly loaned me. That's the most aggressive disk I've ever used; I think it would cut the car in half in 15 minutes! When I got done, i got the clearance Needed and it doesn't even look bad with more radius. Some black duct tape and wolla! It's good now. That was one awesome / fun wheelie and it went forward then started climbing to a pretty steep angle. __________________ Jeff Lee 7494 D/S '70 AMX

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode