HOME FORUM RULES CONTACT
     
   
   

Go Back   CLASS RACER FORUM > Class Racer Forums > Stock and Super Stock Tech

Reply
 
Thread Tools Display Modes
Old 03-29-2014, 07:35 PM   #1
Dave Gantz
Senior Member
 
Join Date: Nov 2005
Location: Verrry South Jersey
Posts: 537
Likes: 134
Liked 251 Times in 125 Posts
Default Re: Breaking bell housings

Quote:
Originally Posted by Ed Wright View Post
About the solid side motor mounts:
If you run a production block (Bow Tie blocks didn't exist when I was showed this.)
Bare block, with something soft below the test cylinder, put an inside mic in the cylinder above the soft pad, front-to-rear, up top, barely tight enough to stay in place. A healthy guy with hand above & below the mic, press hard & fast together and watch the mic fall to the pad. The old guy-machinist that showed me this about 50 years ago was no body builder either.
Think about your ring seal during launch in the cylinders next to those solid motor mounts. I would use a torque strap with stock mounts myself.
I remember reading years ago that Bob Glidden built engines on the floor so that the cylinder walls would'nt distort. That made me think some, and that usually hurts!
Dave Gantz is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 10:07 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
Copyright Class Racer.com. All Rights Reserved. Designated trademarks and brands are the property of their respective owners.