|
|
10-23-2014, 01:23 AM
|
#12 |
|
Senior Member
Join Date: Mar 2002
Location: Sulphur Springs Texas
Posts: 743
Likes: 148
Liked 166 Times in 46 Posts
|
Re: ATI Balencer removal
I had one like that. Put as much pressure on the puller as you think it will stand, then hit the jam bolt with a hammer right on the end and hit it hard. Keep tightening the puller and repeating the process. That is what I had to do to get one off that was not honed before it was installed. Good Luck.
|
|
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode