Woodfin's SS GT/TB construction series

FireSale · 02-12-2015, 09:40 PM

Looks good, Larry.

I just finished fabricating a shift mount for the Quarter Stick in my Mustang. It's wedge shaped sloping down towards the front to straighten the stick out for the 2-3 pull. The lever could mount to the side like you have going. The car is buttoned up for a coat of primer right now. I'll post a pic of the shifter setup in a few days. Between your build and Rich Taylor's Ford vs Chevy thread I get a lot of useful ideas.

I'm sure he reads this, so thanks to both of you.

Dale

02-12-2015, 09:40 PM	#28
FireSale VIP Member Join Date: Feb 2014 Location: Lakewood Washington Posts: 1,407 Likes: 29 Liked 237 Times in 126 Posts	Re: Woodfin's SS GT/TB construction series Looks good, Larry. I just finished fabricating a shift mount for the Quarter Stick in my Mustang. It's wedge shaped sloping down towards the front to straighten the stick out for the 2-3 pull. The lever could mount to the side like you have going. The car is buttoned up for a coat of primer right now. I'll post a pic of the shifter setup in a few days. Between your build and Rich Taylor's Ford vs Chevy thread I get a lot of useful ideas. I'm sure he reads this, so thanks to both of you. Dale

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode