Woodfin's SS GT/TB construction series

[Michael Compton]

Good choice on the carb! Those folks have been wonderful to deal with on our cars. Keep up the pics! I enjoy the progress.

Michael Compton

[Dragsinger]

Sean,

got ya covered.

*Momentary toggle on - off - on. Works either way

*RacePac fuel pressure sensor

*Aeromotive sampling valve

*Wiring runs for fuel pump toggle, pressure sensor, temp sender, water pump & fan.

[Dragsinger]

In case the 3.5" x 54" Aluminum driveshaft pitches it's self out of the truck we have evidence of it installed

I like the "bolt on" Strange yoke, having installed one in several buildups.

Also, We have seen comments about CMD anti-seize lube. The last set of Callies rods I bought included a small tube of CMD in the box. Callies recommends it on the rod bolts. Later I bought some larger tubes and have used it in the correct places, example, with the u-joint caps shown here.

[Dragsinger]

CMD lube = good stuff

http://www.cmdlubeoil.com/extreme_pr...ubricants.html

[Dragsinger]

Some minor catch up notes. The last few days have brought several completion items.

*Fuel system plumbing finished
*Brake system finished
*Rear axle assemble finished
*Engine finished
*Transmission finished
*Driveshaft installed
*Shifter installed
*RacePak roughed in
*Most wiring roughed in and terminated on at least one end
*Gauges finished

[Dragsinger]

a few more catch up notes;

photo # 191 junction on front motor plate.

*fuel pump momentary for fuel check
*water pump
*fan

This allows wiring to be dis-connected as needed.

Photos #192 & 193 show how the wiring "will not look" in a few days. It will all be bundled and finalized right away.

[HandOverFist]

I have the same fuel sample valve on the Mustang...nice piece.