75 Nova U/SA

[bob3240]

Speaking of which, Mike please call me at 513-836-3648. Bob Michael. Leave message with your number if I don't pickup. Thanks.

[MikeMoller]

Originally Posted by bob^3240

Speaking of which, Mike please call me at 513-836-3648. Bob Michael. Leave message with your number if I don't pickup. Thanks.

Bob,
Great to talk to you , thanks for the info.

[Dwight Southerland]

Mike - I totally understand. Go have some fun!!

[MikeMoller]

Didn't get the 350 done for Charlotte, so took car as is since track is downhill and weather looked good. Was hoping to run fast enough to ask for HP reduction, didn't happen but actually got to third round. Surprise!

Then I get an offer of 'loaner' 305 thru the generosity of a gentleman racer, so stopped all and went and got it. Spent the week prior to VMP LODRS putting it in, building a carb, guessing at the tuneup. So the VMP results were 3 runs under the R/SA index, 13.743, 13.91, 13.687(1st round loss broke out on 13.79 dial and pretty hard on the brakes) under very good conditions. Since the timing, jetting, header setup were pretty much a guess I was pretty happy. Only change was from a 28 tall bias slick to a 30 tall radial to cut down the trap rpm which was 6700. That was done after the first run, better at 6300. Can't wait for a test and tune session.

[Dan Fahey]

Originally Posted by MikeMoller

Didn't get the 350 done for Charlotte, so took car as is since track is downhill and weather looked good. Was hoping to run fast enough to ask for HP reduction, didn't happen but actually got to third round. Surprise!

Then I get an offer of 'loaner' 305 thru the generosity of a gentleman racer, so stopped all and went and got it. Spent the week prior to VMP LODRS putting it in, building a carb, guessing at the tuneup. So the VMP results were 3 runs under the R/SA index, 13.743, 13.91, 13.687(1st round loss broke out on 13.79 dial and pretty hard on the brakes) under very good conditions. Since the timing, jetting, header setup were pretty much a guess I was pretty happy. Only change was from a 28 tall bias slick to a 30 tall radial to cut down the trap rpm which was 6700. That was done after the first run, better at 6300. Can't wait for a test and tune session.

Very cool!
D

[jim morgan]

Congrats to Mike, semi final finish @ccra race @ GALOT Saturday

[joe huestis]

Originally Posted by jim morgan

Congrats to Mike, semi final finish @ccra race @ GALOT Saturday

Mike also went to the semi finals at the rained out divisional @ Darlington a few weeks ago which will be completed @ Piedmont later this month. Has been very consistent and going rounds !!