Woodfin's SS GT/TB construction series

[Dragsinger]

Dale,

I will ponder your question and get back to you.

The relay board is part of the Digital Delay package that includes the dash switch controller that is also the dial-in display module. The dial-in showing on the switch panel is also showing on the outside mounted display board. It is a convenient package.

I will have it powered up soon and post photos.

Another relay/fuse board I use and like is "Nitrous Dave's Race Electronics" [or something close to that] He sells just the relay board to use with your switches. It is a good product and good value.

More soon.

[Mark Markow]

hey Larry in order for the g meter in your racepak to work properly. it has to be mounted flat and pointed in the direction of travel. standing it up like yours is not good.

[HandOverFist]

Set up for wheelstands?

[Dragsinger]

Mark, I knew that and forgot, Thanks for the reminder. Originally I had it mounted correctly but, "revised/improved" the mounting

I appreciate the catch and will change to "revision" three.

[Dragsinger]

Dale,

the bulbs you intend to turn on, do those bulbs have two wires [bat & ground?] Are the wires accessible?

If so, the MSD three step can apply either bat + or ground to one side of the bulb. The other bulb wire will either be connected to bat + or ground as needed.

You can experiment with the setup by using a 3000 chip to test each function.

[Dragsinger]

Dale,

might not be clear, of course I understand the bulbs have bat + and ground. Question, do you have access to the bulb wires [that is to say, the wires are not part of a solid state board.]

[Dragsinger]

about those bulbs, when you find yourself in a hole, quit digging :}