C4 Corvette build for Superstock I-J-K

[Ernie Neal]

Originally Posted by Robert Simpson

Ernie, great build I like the layout. Would you happen to have any pictures of the clutch linkage installed? I am thinking that you are using a bell crank under the floor pan or under the dash dropping down to the clutch fork?

Thanks

Robert,
my clutch linkage is inside the car similar to what old 55-57 Chevys were. I had 1 shot of one of the ends I made to hold the cross shaft. I used bearings on each end. These are welded to the dash bar. The rod drops through the floor just past the accelerator pedal.

The other picture is all the pieces that comprise the linkage before welding.

Ernie

[MR DERBY CITY]

Will you be able to find a midget in the Columbus area to crawl around the bars inside of the car to glue the carpet in ? Perhaps some one that lost their job with the B and B circus ? LOL........

[Ernie Neal]

Originally Posted by MR DERBY CITY

Will you be able to find a midget in the Columbus area to crawl around the bars inside of the car to glue the carpet in ? Perhaps some one that lost their job with the B and B circus ? LOL........

Come on M J, I was the midget. I do have to figure out the front part, more than likely need your help, again!!

Ernie

[MR DERBY CITY]

Originally Posted by Ernie Neal

Come on M J, I was the midget. I do have to figure out the front part, more than likely need your help, again!!

Ernie

Oh,....so glad to hear that your health is improving......

[Ernie Neal]

Originally Posted by MR DERBY CITY

Oh,....so glad to hear that your health is improving......

thanks M J, I feel good only sore. Tomorrow will be 3 weeks. I might get to drive after my doctor visit tomorrow.

Ernie

[Ernie Neal]

Well, these photos are mostly of final assembly of a lot of underhood components. Had to make that tight fitting cranktrigger bracket on the drivers side.

[MAURICE BLENDHEIM]

Ernie…Beautiful job on the building of your car. Can't wait to see pictures of it on the ground with the wheels on. Really like the two tone silver colours. Good Luck at the Doctor today. Maurice