96 Mustang FGT/G

[George Wright]

Originally Posted by ALMACK

Looks good George.

How did you mate the cogged water pump pulley to the 5.0 Coyote water pump ?

Did you have to machine an adaptor ?

Alan,
Thanks. We machined an aluminium hub with several counter bored holes to bolt to the OEM water pump drive flange, then we bolted the plastic drive pulley over that in a separate set of threaded holes. The bracket to hold the electric motor is an extended / modified Mr. Gasket bracket. I have already fabricated 5 of these set-ups for various Coyote installs. If this keeps up at some point I will have to have the brackets water jetted.