1971 Torino 500 2 door hardtop

[FireSale]

Originally Posted by Rose Racing

I did not know of the tolerance rule. I cant find any 1.79 intake valves except for a 4.6 ford

Stock: Cylinder Heads: Page 135 or so.

"Valve-diameter tolerance:+.005-inch or -.015-inch from NHRA Specs."

[Rose Racing]

I got the Moser Engineering axles and spool during christmas and I still need to order Ring and pinion as well as installation kit and Spool bearings. I need to pull center section out but weather is getting in the way.... I am first going to order some transmission components before I order the rest of the rear end components because I dont see the weather breaking soon.(The car is outdoors) Bracket car is in the one car garage)

[FireSale]

Originally Posted by Rose Racing

I got the Moser Engineering axles and spool during christmas and I still need to order Ring and pinion as well as installation kit and Spool bearings. I need to pull center section out but weather is getting in the way.... I am first going to order some transmission components before I order the rest of the rear end components because I dont see the weather breaking soon.(The car is outdoors) Bracket car is in the one car garage)

Building in the drive with a bracket racer in the only garage space......You married? If so, your wife and mine could trade stories.

Sandusky, huh? Born and raised in Toledo, here. Currently a lifer in Washington State. "Staff Photographer" at Milan in '66-'67 ish.
Good luck with the build.

[Rose Racing]

Originally Posted by FireSale

Building in the drive with a bracket racer in the only garage space......You married? If so, your wife and mine could trade stories.

Sandusky, huh? Born and raised in Toledo, here. Currently a lifer in Washington State. "Staff Photographer" at Milan in '66-'67 ish.
Good luck with the build.

Thanks and no not married just very limited with space and cool Toledo is getting nicer by the day a lot better than the CLE...

[GTX JOHN]

No one is better that George Thompson owner "Carb. Flow Engineering"
on the Autolite carbs.

His 73 Ford 351 Mustang H/SA held the National Record and was
Insanely Fast AND built entire in house front to back by George!

He is in Lake Havasu Arizona......(661) 857 -0109

[Capri]

Nope. Then Autolite carbs are so difficult to work on.............. Really Really difficult to make them work well............. Now them Motorcrafts on the other hand...........

[Rose Racing]

90484924_3817765848263838_4389787288993792000_n[1] Some updates to the build I Took axles out and got new Moser 33 spline axles